SUPER SLICER GAP FILL UPDATE

I can provide examples of Superslicer vs Cura if necessary. I still think Superslicer it is a better slicer overall but the move planner has definitely fallen behind and for those trying to reduce print time, every extra move counts. The paths in that seem to minimize the travels and total movement of the nozzle in a layer. Other slicers like Cura 5 and Simplif圓d don't have this issue. This is extremely noticeable on small parts. Add physical printer settings as env variables for post-process scripts 2282 Post-process script execution: now add python/perl before a. When Gap fill is enabled, it seems to over-extrude causing edges with a lot of artifacts. gapfillminlength: will remove the extrusion is too short Supports layer height now try to respect the zstep a bit more. I've been using Superslicer for a couple years now and I'm pretty well versed in the settings. gapfillextension: increase the length of the gapfill by stretching it. preview when using Creality Print, Ultimaker Cura, Prusa Slicer, and Super Slicer. Arachne will spread that 0.1 between adjacent perimeters, avoiding the need for the additional pass. If you have a Creality Printer, Creality Slicer is optimized for you. I'm thinking, Could THAT be the cause of the problems So I use the Expert Mode in the PRUSA Slicer to set the Gap Fill Speed to zero, which basically tells it NOT to do any actual gap filling operations when printing. For thin parts that are mostly walls, thin walls and gap fill, I often find that the paths on a single layer in superslicer will be travelled nearly twice by the nozzle because the travels and backtracking become so excessive. If we wanted to use a thickness of 2.1mm for example, I would make 4 passes of 0.5, and an additional pass of 0.1 to fill the gap, which would be a waste of time. It's only a little bit of gap fill, but each subsequent layer, on up to the top, there's additional gap fills. I know it's complex, but Cura 5.0 is leaps ahead on this. everything seems ok (tiny gap between nozzle and bed, roughly 0.

SUPER SLICER GAP FILL UPDATE

Is there any fix for this in the works? I have a very similar model that has given me excessive travels on gap fill, but I've been getting increasingly annoyed with the seemingly illogical move and travel planning implemented by superslicer. After installing the appropriate firmware, update your slicers settings to remove.

Super slicer gap fill